“Critical” step to obtain a “smooth” and “uniform finish” when painting ceilings

Doing the paint job yourself is often much cheaper than hiring a professional to do the job. Although it may require a little more research and planning beforehand, the results can often look alike. According to Dulux, using an unloaded roller while the paint is still wet is “crucial” to getting a nice finish.

DIY experts have shared that the first step to painting any ceiling is to “prep” the room.

They said, “All good projects start with good preparation.

“So clean your area, lay down a drop sheet, then grab a ladder, brush, tape, roller and extension pole and a tray.

This includes removing furniture from the room or walls so you can reach edges and cover floors and anything the Brits don’t want to be splashed with tarpaulins.

People can use burlap sheets, but old sheets work just as well and don’t require the extra expense – Remove light shades and any light fixtures possible so you can get straight to the edges when painting.

READ MORE: Grand design: Couple change their minds at the ’11th hour’ over £300,000 home

The edges of the ceiling must then be masked to avoid having paint on the joining walls.

Use decorator’s tape to mask off the area where the ceiling meets the wall or cornice for those who have it.

Do-it-yourselfers may want to paint the molding at the same time, in which case mask off the area where the molding meets the wall.

Once the walls are masked and cleaned, it’s time to paint.

Experts continued, “Just like a vertical wall, start by cutting where the roller won’t reach.

It is important to roll as far as possible in the previously brushed sections.

The painting gurus added: “Now that you have finished most of your ceiling, and while it is still wet, you can start laying down the paint.

“This is a crucial step in achieving a smooth, even finish.

“Using an unloaded roller, start at the upper left corner of your ceiling and gently pull straight out towards you with no pressure.

“A touch of lightness will prevent the formation of new brushstrokes. Repeat this action and slightly overlap your last stroke so that your roller erases the line created by the previous stroke.

If the ceiling requires two coats, simply wait two hours for the first coat to dry, then start at step four and recut the ceiling.

Leave a Comment